Instructions / Assembly

ManualsBrandsGemmy ManualsKitchen6.4 ft. Wicked Witch of the West with Broom

62376 E

Congratulations! You are the proud owner of a Life-Size Figure. Please read over the

directions carefully before using your new ﬁgure.

Please keep these instructions for future reference because they contain important information.

PACKAGE CONTENTS

Base 1 piece

Torso 1 piece

Head 1 piece

Costume 1 piece

Broom 4 pieces

Hat 1 piece

Leg supports 4 pieces

Cape 1 piece

Base poles 4 pieces

Curving Pole 1 piece

Crossbar Support 1 piece

UL/CUL Listed Switching Adapter 1 piece

Input: 100-240V ~50/60Hz

Output: 6V 1000mA

PREPARATION

Estimated assembly time: 15-20 minutes.

Before beginning assembly, remove all parts from carton. Compare parts list and diagram above. If any part is missing or

damaged, do not attempt to assemble or use the product.

ASSEMBLY INSTRUCTIONS

1. Set base and pieces on a clear, ﬂat surface and assemble leg supports as

shown in illustration 1. If placed on uneven surface, please insert the four

pieces base poles into the corners of base.

2. The character suit MUST be placed over the leg supports BEFORE the rest of

the Crossbar Support is assembled.

3. Assemble the Crossbar Support as shown in illustration 1. Place curving pole

into the hole located on top of crossbar support as shown in illustration 2.

4. Attach torso onto frame as shown in illustration 3.

5. Finish putting the character clothes on frame by pulling the arms gently through

sleeves. Secure the suit in the back by loop fastener. Adjust as desired.

6 . Assemble broom as illustration 4 shown, slide the broom through the left hand.

Adjust as desired.

7. Attach head as shown in illustration 3, make sure it clicks securely into place.

Put hat on top of the head, tie cape to neck and adjust as desired.

8. Connect control cord on base to match connection on torso.

9. Plug in adapter on base. This power unit is intended to be correctly oriented in

a vertical or ﬂoor mount position.

10. Unplug adapter when not in use.

FIGURE FUNCTIONALITY

Two-way toggle switch is located on the back of body.

OFF: Slide switch to “OFF” position to deactivate the item.

SENSOR: Slide switch to “SENSOR” position, simply make a noise or wave hand near item in front of base or walk by to activate.

ANIMATED FIGURE

INSTRUCTIONS

Front

Illustration 1

Illustration 3

Illustration 4

Illustration 2