Instructions / Assembly

4
CAUTION: The frame straps (ties) should not be placed around any of the electrical wires during assembly!
Disassembly Instructions --- Perform the above steps in reverse order.
Approximate Assembly time: 10 to 15 minutes.
USER SERVICING INSTRUCTIONS
Fuse Replacement
WARNING:
Risk of Fire: Replace fuse only with 3 Amp Max, 125 Volt (provided with product).
WARNING:
Risk of Fire: Do not replace the attachment plug. Contains a safety device (fuse) that
should not be removed. Discard product if attachment plug is damaged.
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on the cord.
2. Open fuse cover. Slide open the fuse access cover on top of the attachment plug towards blades (see
illustration).
3. Remove fuse carefully.
4. Replace only with same size and type of fuse.
5. Close the fuse cover. Slide closed the fuse access cover on top of the attachment plug.
To replace lamp:
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Pull lamp and plastic base straight out of lampholder.
3. Replace lamp with 3.4 Volt, 0.41 Watt regular brightness type lamps(provided with product). If the new lamp base
does not ft in lampholder, follow the steps below before step 3:
a) Remove the base of burned out lamp by straightening lamp leads and gently pull lamp out.
b) Thread leads of new lamp through holes in old base with one lead in each hole.
c) After lamp is fully inserted into base, bend each lead up, like other lamps in the light set so that the leads will touch
the contacts inside the lampholder.
CAUTION
1. Risk of fire. This product does not contain lamp shunts,which allow the product to operate if one lamp burns out. Do
not replace lamps with other than the spare lamps provided with this product.
2. To reduce the risk of fire and electric shock: a)Do not install on trees having needles, leaves or branch coverings of
metal or materials which look like metal. b)Do not mount or support strings in a manner that can cut or damage wire
insulation.
CAUTION
1. Use 3.4 volt, 0.41 watt steady lamps only (provided with product).
WARNING
Strobe lights have been known to trigger seizures in people with photosensitive epilepsy.
Do not remove light string off the product and hang on trees or other places for decoration.
DISASSEMBLY INSTRUCTIONS
Please refer to assembly instruction above, however in reverse order.