User Manual

BW1251 Nov 15, 2006
Browan Page 60 of 72
You can configure your SNMP agent to send SNMP Traps (and/or inform notifications) under the
defined host (SNMP manager) and community name (optional).
Figure 69 – SNMP Trap table settings
Click Add to add a new SNMP manager or Delete to delete a specific SNMP manager. Clicking Add:
Figure 70 – Add SNMP Trap
Host IP – entering the SNMP manager’s IP address [dots and digits].
Host Port – entering the port number the trap messages should be send through [number].
Trap Type – selecting trap message type [v1/v2/inform].
Community – specifying the community name at an SNMP trap message. This community will be
used in trap messages to authenticate the SNMP manager. If not defined, the default trap community
name will be used (specified in the SNMP table) [1-32 all ASCII printable characters, no spaces].
Save – saving all current settings
Cancel – restoring the last settings
System | Telnet
Use System | Telnet menu to manage the telnet/SSH service of your BW1251.
Figure 71 – System Configuration settings
Telnet Service – Enabling or disabling telnet service of BW1251
SSH Service – Enabling or disabling SSH service of BW1251.
The default of these two services are all Enabled. The current IETF SSH (SSHv2) is supported for
security of accessing BW1251 via telnet/CLISH.
System | Configuration
Use the System | Configuration menu to configure such system utilities: