User Manual

Cha

5 Home Network Confi

uration

98 4030765 Rev 01

2 Click WAN Setup. The WAN Quick Setup screen opens.

Q. to reviewers click edit or add to see the next fields.

3 In the Broadband Type field, select DSL.

4 In the DSL Mode field, select ATM. More fields populate on the screen.

5 Complete the following fields on the screen as follows:

Note: This configuration is an example of a specific setting for the residential

gateway. Your values may differ depending upon your service provider.

a In the Broadband Connect Type field, select PPP over Ethernet (PPPoE).

b In the Encapsulation Mode field, select LLC/SNAP - Bridging.

c Check the VLAN Mux - Enable Multiple Protocols Over a Single PVC

check box.

d In the PPP Username: field, enter the user name for the point-to-point

protocol.

e In the PPP Password: field, enter the pasword for the point-to-point protocol.

f In the PPPoE Service Name: field, enter the name for the point-to-point over

Ethernet service.

g In the Authentication Method field, select auto from the drop-down list. Auto

turns on authentication automatically.

h In the VPI field, enter the virtual path identifier (VPI). Values are: 0 to 65535

i In the VCI field, enter the virtual channel identifier (VCI). Values are:

0 to 65535

j In the Service Category field, select UBR Without PCR.

k In the Authentication Method field, select AUTO.

l Select the Enable IGMP Multicast check box.

m Select the Enable WAN Service check box.

6 Click Add.

7 Click Reboot

. This action reboots the residential gateway so that the WAN setup

configuration takes effect.

3-6-2009 Draft