User Manual Part 2

Cha
p
te
r
3 Confi
g
uration and O
p
eration
24 4020210 Rev
A
15 In the Wireless Mode field, select one of the following modes:
 802.11g & 802.11b
 802.11g only
 802.11b only
16 In the 54g Protection field, select Auto to enable 54g protection or Off to disable
the function. The Auto option will use RTS/CTS to improve 802.11g performance
in mixed 802.11g/802.11b networks. Turning the protection off maximizes
802.11g throughput under most conditions.
17 Click Next. The (Setup Wizard 4/4) ----- Wireless Security Settings screen opens.
18 In the Select SSID field, select the SSID from the drop-down list that you want to
use.
19 In the Network Authentication field, choose one of these two options for the
authentication method:
 Open. All devices may access the wireless network when WEP Encryption is
disabled. When no authentication is required and if encryption is disabled,
then the data that is passing between the access point and the client is also
not encrypted. When WEP is enabled, the data is encrypted, but the client is
not authenticated.
 WPA/WPA2. See Securing Your Wireless Network with Encryption Keys (on
page
120).
20 Do you want to enable WEP Encryption?
 If yes, in the WEP Encryption field, select Enabled from the drop-down list.
 If no, in the WEP Encryption field, select Disabled from the drop-down list.
21 Click Save/Reboot to save the changes you made. You must reboot the gateway
for the changes to take effect.