User Manual Part 3

Cha
p
te
r
5 Home Network Confi
g
uration
104 4020210 Rev
A
c Check the VLAN Mux - Enable Multiple Protocols Over a Single PVC
check box, if applicable.
d In the PPP Username: field, enter the user name for the point-to-point
protocol.
e In the PPP Password: field, enter the password for the point-to-point
protocol.
f In the PPPoE Service Name: field, enter the name for the point-to-point over
Ethernet service.
g In the VPI field, enter the virtual path identifier (VPI). Values are: 0 to 65535.
h In the VCI field, enter the virtual channel identifier (VCI). Values are:
0 to 65535.
i In the Service Category field, select ABRI Without PCR.
j Check the 'Enable Quality of Service' check box if applicable
k In the Authentication Method field, select AUTO.
l Check Enable NAT.
m Check the Enable IGMP Multicast check box, if applicable
n Check the Enable WAN Service check box
7 Click Save to save your settings.
8 Click Reboot. This action reboots the residential gateway so that the WAN setup
configuration takes effect.
Configuring the WAN Interface (MER Broadband Type)
To configure a WAN interface for MAC Encapsulation Routing (MER) broadband
type, complete the following steps.
1 Click Home Network on the main screen. The Client Summary screen opens.