User's Manual Part 1

User’s Guide Installation
The various states of the LEDs indicate different networking and connection operations as follows:
Item LED Color Status Indication
On P-560 is active/working Green
Blink P-560 is booting
1 Power
Orange On Writing to FLASH memory
On
PPPoE/PPTP/GRE tunnel for DSL is
active on P-560
2 Online Green
Off
No active PPPoE/PPTP/GRE tunnel
for DSL on P-560
3 WAN Orange On WAN active/working
4 WLAN Orange On WLAN active/working
Green On 100 Mbps network connection exists 5 LAN (1, 2, 3, 4)
Orange On 10 Mbps network connection exists
Connectors
The Access Controller has several connectors on the rear panel:
Power
Reset
Internet
LAN 4321
1 2 3 4
Figure 4 – Connectors
Descriptions of the connectors are given in the following table:
Item Connector Description
1 Power For power supply
2 Reset
Reboot or reset to factory defaults.
Press the reset button for less than 5 seconds to reboot the
controller. Press the reset button for more than 5 seconds to
set the controller to factory defaults
3 LAN (1, 2, 3, 4)
For enterprise applications use this port to connect your
company LAN, Intranet or to hotspot access points
4 Internet For Internet connection
Gemtek Systems Page 14