User's Manual Part 1

User’s Guide Installation

The default user login page looks like the picture below:

Figure 9 – Example of a Simple Login Page

You have full flexibility to modify and adapt all these pages to your needs and personal designs. For

initial set up and testing we recommend you use the default configuration, which will present a simple

Enter any start page you like in the user interface | start page menu. In addition you can define a

number of free web sites in the walled garden table on the user interface menu.

For more information on how to build your own user pages please refer to Chapter

4 – User Pages.

Step 6. Change Administrator Password

Before saving your initial configuration don’t forget to change the administrator password in the user

interface | administrator menu.

Step 7. E-mail Redirection

If you have a SMTP mail server available for your subscribers enter its IP address and SMTP port

number in the connection menu under the item e-mail redirection. All outgoing e-mail passing

through the Access Controller will be redirected to this server.

Step 8. Save Configuration and Restart

Make sure you have saved your changes from each of the first seven steps and then press the

restart button on the lower side of the web management screen. After 10-15 seconds you can re-

load the admin pages or start to log on to the Access Controller as a user.

Users connected to the LAN port of the Access Controller can type in any URL in their browser and

they will be redirected to your defined welcome (if enabled) and login pages. Administrators can

monitor connected users via the connection | users menu.

Gemtek Systems Page 21