User's Manual Part 2

User’s Guide Appendix
System Commands
system
access System access configuration.
configuration System configuration.
system access
aaa Multimode settings.
control
Allow or deny management access depending on user network
address.
isolation Isolation setup.
snmp Configuration of SNMP service.
telnet Enabling or disabling of telnet protocol.
uat Universal Address Translation of all IP and proxy settings.
system configuration
clock Manual setting of internal device clock
ntp Configuration of Network time Protocol service.
syslog For sending system and debug messages via syslog protocol.
trace Displays the last logged messages.
System Access Commands
system access aaa
-m <mode_list>
Either disabled or space separated list of modes. Modes may be:
uam, 802.1x, mac.
-u <use_password>
Mac authentication mode password usage: 'radius' - use radius
shared secret key, 'user' - use of user-defined password.
-p <password> User defined mac authentication password.
system access control
<action>
Action to take upon management access entry: A(dd), E(dit),
D(elete) or default.
<id>
Management access entry id. Needed only when editing or
deleting entry.
-s <service>
Services for which the policy should be set: ssh, snmp, telnet or
all.
-a <ip/bitmask> 'all' or network ip address and bitmask to (dis)allow service to.
-p <policy> Management access policy: allow or deny(default is deny).
system access isolation
-b <status> Mac binding status: enabled or disabled.
-i <status> Isolation status: enabled or disabled.
system access snmp
proxies SNMP proxies settings.
settings SNMP service settings.
traps SNMP traps settings.
users SNMP users settings.
Gemtek Systems Page 129