WMIM-205GN User’s Guide 11N mini PCI module
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, and 3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied firmware programming tool. OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain change.
Table of Contents Introduction… … … … … … … … … … … … … … … … … ..1 Hardware Installation… … … … … … … … … … … … … .2 Software Installation… … … ..… … … … … … … … … … .3 Introduction While Orthogonal Frequency Division Multiplexing (OFDM) is adopted by 802.11N for the high-speed transfer rate in a 2.4GHz range. Gemtek’s MXF-M950913GN fully utilizes the benefits of 802.
Hardware Installation Please follow the instruction to install your 11N mini PCI module on your system (for example, your notebook): Step 2 Press it firmly so that the contact edge is driven into the receiving socket. Step 3 Connect the internal antenna. Step 4 Connect the External antenna. Congratulations! You have just completed the Wireless LAN hardware installation. When you boot up the computer, you should expect to see the wireless LAN connection capacity.
has not been installed properly. If there is a yellow mark or red-cross on the network adapter, it may be a device or resource conflict. Replace or update the device driver or consult Windows. at the top of the Preferred networks list. Trouble Shooting If the wireless LAN card does not function: 1. Make sure you have properly installed the driver for the card. 2. Consult the card’s manual or contact the vendor for installation information. Step 4 A Wireless Network Properties window will appear.
Network Authentication Select if your access point requires authentication. Match the authentication used by the network. l Open: No authentication is used. Shared The Pre-Shared Key (PSK) authentication method is used. In enterprises, WPA will be used in conjunction with both Data Encryption Select the type of security encryption algorithm used. The available types of encryption are based on the type of the authentication selected. l l wireless router and authentication server.
Network key Enter the security key for data encryption, when WEP or WPA-PSK is selected. This can be entered in ASCII or hexadecimal for WEP and in ASCII for WPA-PSK. Key index There are four Keys (1, 2, 3, 4) that can be selected for WEP. The key index selected here must match the network key index. The Wireless Network window is displayed and the new network is listed in the Preferred networks area.
