WMIB-150G(R ) User’s Guide 11 b/g Wireless LAN Mini-PCI Adapter
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
and obtaining a separate FCC authorization. This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, 3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied firmware programming tool.
Introduction Table of Contents Introduction……………………………………………..1 Hardware Installation………………………………….2 Software Installation………..………………………….3 While Orthogonal Frequency Division Multiplexing (OFDM) is adopted by 802.11g for the high-speed transfer rate in a 2.4GHz range. Gemtek’s WMIB-150G fully utilizes the benefits of 802.11g standard on the proven compatibility between two transfer modes and the high speed bit transfer that is desirable for multimedia application in Wireless environment.
Hardware Installation Please follow the instruction to install your 11b/g Wireless LAN Mini-PCI Adapter on your system (for example, your notebook): Congratulations! You have just completed the Wireless LAN hardware installation. When you boot up the computer, you should expect to see the wireless LAN connection capacity.
Trouble Shooting If the wireless LAN card does not function: 1. Make sure you have properly installed the driver for the card. 2. Consult the card’s manual or contact the vendor for installation information. Software Configuration If the driver is successfully installed, you can use your Windows XP Wireless Zero Configuration (WZC) utility or the utility tool your vendor provided to manage your wireless adapter.
Key (PSK) authentication method is used. In enterprises, WPA will be used in conjunction with both z z wireless router and authentication server. In Small Office/ Home Office (SOHO) environment, where there are no authentication servers, user can use pre-shared key (PSK) mode in place of the z Disabled: No encryption. WEP: Deselect Network Key is provided for me automatically and enter the Key provided by the network. Available only with Open and Shared Authentication.
Key index There are four Keys (1, 2, 3, 4) that can be selected for WEP. The key index selected here must match the network key index. If the blue bubble does not appear, click Refresh. If it still does not appear, double-check that the wireless settings match the configuration of the wireless network. Step 10 The key is provided for me automatically Select if the key is automatically provided.
