PCI Express Wireless Local Area Network (WLAN) 802.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is This equipment has been tested and found to comply with the limits subject to the following two conditions: (1) This device may not cause for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Industry Canada This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device Caution: The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-channel mobile satellite systems.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, 3) For all products market in US, OEM has to limit the operation End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users
equipment and services; Part 1: Common technical requirements Europe – EU Declaration of Conformity This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test methods have been applied in order to prove presumption of conformity with the essential requirements of the R&TTE Directive 1999/5/EC: - - EN 301 489-17 V1.2.
0560 Česky [Czech] that this [type of equipment] is in compliance [typ zařízení] je ve shodě se základními relevant provisions of Directive 1999/5/EC. Español [Spanish] Por medio de la presente [nombre del fabricante] declara que el [clase de equipo] Undertegnede [fabrikantens navn] erklærer cumple con los requisitos esenciales y herved, at følgende udstyr [udstyrets cualesquiera otras disposiciones aplicables typebetegnelse] overholder de væsentlige o exigibles de la Directiva 1999/5/CE.
dichiara che questo [tipo di apparecchio] è conforme ai requisiti essenziali ed alle altre disposizioni pertinenti stabilite dalla direttiva Latviski [Latvian] Lietuvių [Lithuanian] [Dutch] [Hungarian] Alulírott, [gyártó neve] nyilatkozom, hogy a [... típus] megfelel a vonatkozó alapvetõ követelményeknek és az 1999/5/EC Ar šo [name of manufacturer / izgatavotāja irányelv egyéb elõírásainak.
1999/5/ES. Suomi [Finnish] [Valmistaja = manufacturer] vakuuttaa täten että [type of equipment = laitteen tyyppimerkintä] tyyppinen laite on direktiivin 1999/5/EY oleellisten vaatimusten ja sitä koskevien direktiivin muiden ehtojen mukainen. Svenska [Swedish] Härmed intygar [företag] att denna [utrustningstyp] står I överensstämmelse med de väsentliga egenskapskrav och övriga relevanta bestämmelser som framgår av direktiv 1999/5/EG.
Table of Contents Introduction……………………………………………..1 Hardware Installation………………………………….2 Software Installation………..………………………….3 Introduction While Orthogonal Frequency Division Multiplexing (OFDM) is adopted by 802.11a/b/g/n for the high-speed transfer rate in a 2.4GHz and 5GHz range. Gemtek’s WPEA-113N fully utilizes the benefits of 802.
Hardware Installation Congratulations! You have just completed the Wireless LAN Please follow the instruction to install your 11a/b/g/n mini PCI module on your system (for example, your notebook): hardware installation. When you boot up the computer, you should expect to see the wireless LAN connection capacity.
Trouble Shooting If the wireless LAN card does not function: 1. Make sure you have properly installed the driver for the card. 2. Consult the card’s manual or contact the vendor for installation information. Software Configuration If the driver is successfully installed, you can use your Windows XP Wireless Zero Configuration (WZC) utility or the utility tool your vendor provided to manage your wireless adapter. To enable the wireless connection: Step 1 A Wireless Network Properties window will appear.
Open: No authentication is used. Shared The Pre-Shared Key (PSK) authentication method is used. In enterprises, WPA will be used in conjunction with both authentication selected. wireless router and authentication server. In Small Office/ Home Office (SOHO) environment, where there are no authentication servers, user can use pre-shared key (PSK) mode in place of the Disabled: No encryption. WEP: Deselect Network Key is provided for me automatically and enter the Key provided by the network.
hexadecimal for WEP and in ASCII for WPA-PSK. Key index There are four Keys (1, 2, 3, 4) that can be selected for WEP. The key index selected here must match the network key index. The key is provided for me automatically Select if the key is automatically provided. Most often, the key is not automatically provided, so you have to un-check this box and enter the network key. If using a RADIUS server, the key is automatically provided.
