VS10408 User’s Guide Wireless 802.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
EC DECLARATION OF CONFORMITY (EUROPE) ViewSonic Corporation declares that the device conform to the specifications listed below, following the provisions of the European R&TTE directive 1999/5/EC, EMC directive 89/336/EEC, and Low Voltage directive 73/23/EEC: For 2.4 GHz devices with 100 mW radios, the following standards were applied: • ETS 300-826, 301 489-1 General EMC requirements for is subject to licensing. Radio equipment.
standard on the proven compatibility between two transfer modes and the high speed bit transfer that is desirable for multimedia application in Wireless environment. Introduction Augmenting the first ever 54Mbps transmission on the 2.4GHz bandwidth, ViewSonic is presenting to the WLAN community another high-speed option that is backward compatible to the well accepted 802.11b WLAN technology. In order to supplement the compatibility between 802.11b and 802.
Hardware Installation Configuration Thank you for purchasing the wireless PCI adapter. The following instructions will walk you through installation of the PCI. If using Windows XP, you can use the Windows XP Wireless Zero Configuration (WZC) utility to manage your wireless client adapter. You have the second choice. ViewSonic also provides you the wireless configuration utility. Step 1 Insert the supplied CD-ROM into the CD-ROM drive. The software automatically starts the Installation Wizard program.
and the value is case sensitive. Step 6 If the network requires Network Authentication, select the type of authentication required. WPA might require further Authentication options found on the Authentication tab. Match the setting used by the network. Step 7 Enter information for the new wireless network based on the descriptions in the following: Network Authentication Select if your access point requires authentication. Match the authentication used by the network.
(802.1X) is used with an EAP type. WPA consists of three main elements: an Authentication Server (typically a RADIUS server), WPA-enabled router or AP (called "Authenticator"), and a WPA-enabled client (called "Supplicant"). ! WPA-PSK: WPA authentication (802.1X) is used with a Pre-Shared Key, which enables you to enter a static Network key. Data Encryption Select the type of security encryption algorithm used. The available types of encryption are based on the type of the authentication selected.
computer-to computer (ad hoc) network. If you are attempting to connect to an infrastructure network, then do not select this setting. Step 8 After entering the information for this network, click OK. The Wireless Network window is displayed and the new network is listed in the Preferred networks area. Step 9 Your computer is connected to the selected network when you see a blue bubble on top of the icon for that network. If the blue bubble does not appear, click Refresh.
