User Manual Part 1

Wireless Nd1 Router User Guide
1. Disconnect the printer from your computer and Plug the thin rectangular end of the USB cable
into the USB port on the router.
2. Connect the power supply to your printer and turn your printer on.
3. Start a Web browser. In the location or address line type
192.168.2.1 and press ENTER.
Note: If you have modified your router's IP address, enter the new IP address
instead of 192.168.2.1.
4. When the user name and password window appears, type in the user name and the password
you created. Click OK to load the router's setup page.
Note: You are not prompted to log in the first time you connect to the router
configuration pages. During the Setup Wizard procedure, you created a user name
and password to log on to the router. You will need to use these whenever you log
on to the router. The user name and password are case-sensitive.
5. In the Device section of the
Status page, look for the Printer status and Printer location
information. Write down the Printer location address. You need the address to set up the
printer on computers that are connected to your network that you want to have access to the
printer.
file:///G|/CSO/Documentation/Documentation%20-%20Draf...Mach-1%20Router/User%20Guide/English/mac_printer.html (2 of 7)9/14/2006 2:44:21 PM