User Manual Part 2

Wireless Nd1 Router User Guide
The settings on the firewall software on your computer apply
only to your computer. The firewall settings for the router
apply to your entire network.
Also, if you have had to configure your firewall software on
your computer to opening specific ports for Internet based
games or applications, VPN clients, VoIP services, etc., they
may also need to be opened on your router. See the
documentation for the application or service to determine if
you need to set any
Port Forwarding or Port Triggering settings
on your router.
What can I do if the specified installation procedure did not work?
1. Try unplugging the power supply of your cable or DSL modem then
plugging it back in to reset it.
2. Restore the factory default settings of the router. Press in and hold
the Reset button for between five and ten seconds. This will reset
the router to the factory default settings. If you applied any personal
configuration settings, you will need to make the changes again.
What type of cable do I need to use to connect my broadband modem to the
router ?
Some types of broadband modems require that you use a cross-over cable
to connect to the router. Use the cables that were included with your
router and with your broadband modem. Contact your ISP if you are still
uncertain about which type of cable you must use.
Does the router support IPSEC?
file:///G|/CSO/Documentation/Documentation%20-%20Dra...5464%20Mach-1%20Router/User%20Guide/English/faq.html (2 of 6)9/14/2006 2:44:33 PM