User Manual Part 2

Wireless Nd1 Router User Guide
installing it for the first time. Alternatively, you can restore your settings if you
have made a backup of your router settings.
A. With a thin tool, such as a paper clip, press the Reset button on the back of the
router for 7 seconds.
B. Wait about 30 seconds for the LEDs on the router to stabilize.
C. Try to access the router's Web address at
192.168.2.1
D. If the router's Web interface still doesn't appear after you have restored to the
factory default settings, it's possible that the router has failed. Please contact U.
S. Robotics Customer Support.
Verify your router's connection to the Cable or DSL modem
1. Check your cable/DSL modem's power and status LEDs to verify that the modem is powered
on and connected to the Internet. Refer to your modem's documentation for information on
its status indicators.
2. In the router configuration pages, click the
Status tab.
3. Click Refresh to update the page with the most current status information.
4. Go to the WAN section of the page and verify that the router has a WAN IP address (such
as 235.42.181.5). This IP address indicates whether the router is connected to the cable/
DSL modem.
5. If the router doesn't have a WAN IP address, reboot the router.
6. If you still cannot access the Internet, click the
Internet tab and use the page to configure
the router's Internet connection. (If you have a DSL modem, you may be required to enter
the login information your ISP provided.)
file:///G|/CSO/Documentation/Documentation%20-%20Draf...%20Mach-1%20Router/User%20Guide/English/trouble2.html (6 of 8)9/14/2006 2:44:36 PM