User Manual Part 3

Wireless Nd1 Router User Guide

9. Type the following command but DO NOT PRESS ENTER: tftp -i 192.168.2.1

put 5464.usr

10. Unplug the power supply of the Wireless Nd

Router.

11. Plug the power supply of the router back in.

12. Immediately press ENTER in the dialog box on your computer to execute the

command.

13. You should now see a message in the command prompt stating the image was

transferred. Wait for the upgrade to finish. When the Wireless LED turns on, the

upgrade is done.

You must now set IP addressing for the NIC back to "Obtain an IP address

automatically."

1. On your desktop, right-click Network Places or Network Neighborhood and

select Properties.

2. On the Configuration tab, select the NIC that connects the computer to the router

and click Properties.

3. On the General tab of Local Area Connection Properties, select Internet

Protocol (TCP/IP) and click Properties.

4. Select Obtain an IP Address Automatically and click OK, then click OK again.

Return to Troubleshooting page

file:///G|/CSO/Documentation/Documentation%20-%20Draf...%20Mach-1%20Router/User%20Guide/English/trouble7.html (6 of 7)9/14/2006 2:44:39 PM