Installation Instructions

E1000 Series Safety and Installation Instructions
SI-00101 v2 10
connectors. Depending on the antenna type chosen, the LTE antennas can be
screwed directly onto the connectors (via a Type N male to N male connector if
the antenna has a Type N female connector) or can be connected via coaxial
cable fitted with a Type N male connector.
Ethernet connectivity and 56 VDC power supply is achieved through the RJ45
Ethernet/PoE+ port.
The GNSS antenna port is fitted with a 50-ohm Type N female connector.
Mounting Points
The mounting kit screw holes are located on the rear of the E10xx as shown in
Figure 5. The centres are on a 100 mm x 100 mm grid, threads are M5 (coarse
pitch) depth 12.5 mm.
Figure 5 - Mounting kit screw holes
Figure 4: GNSS antenna port