Installation Instructions

E1000 Series Safety and Installation Instructions
SI-00101 v2 16
Install the LTE antennas
Antennas that are equipped with a Type N male connector may be fitted
directly to the connectors on the E10xx. Alternatively, antennas may be
mounted separately from the E10xx using their own mounting kit and
connected to the E10xx using coaxial cables terminated in Type N male
connectors.
For 2x2 MIMO operation, two LTE antennas are required. If separate antennas
are used, you should consider mounting them independently of the E10xx so
that their spatial separation is not limited by the spacing of the connectors on
the E10xx.
For SISO operation, only one LTE antenna is required, and this must be
connected to the primary antenna connector shown in Figure 3. The diversity
antenna connector must be fitted with a protective cap and sealed.
Install the GNSS antenna
The E10xx has embedded GNSS functionality for frequency and timing
synchronization. It is supplied with an all-weather GNSS antenna with a
permanently connected cable which is terminated with a Type N male
connector as shown in Figure 13. The antenna has an internal 1-inch diameter,
14 threads per inch, screw thread for fitting onto the end of a pole with a
matching external screw thread. The coaxial cable can be routed within the
pole or outside it. The antenna must be in a good position to receive GNSS
signals.
Figure 13 - GNSS antenna