Installation Instructions

E1000 Series Safety and Installation Instructions
SI-00101 v2 19
connected properly to the equipment that provides the E10xx with its
backhaul connection.
Sync indicator
Following power up, the Sync indicator remains off until the integrated
GNSS function is activated. Once the GNSS function has been
activated, the Sync indicator blinks slowly until enough satellites have
been acquired for a timing lock. Once lock has been achieved and the
E10xx has a good synchronisation source, the Sync indicator shows
steady green. The process of acquiring satellites can take of the order
of 20 minutes in the worst case. If the Sync indicator does not show
steady green after 30 minutes, ensure that the GNSS antenna has a
clear view of the sky and check its RF connection to the E10xx.
User indicator
When power is applied, the User indicator remains off until the E10xx
checks the value of the OAM parameter AdminState. If AdminState is
Locked the User indicator blinks slowly. The cell will not come on air
until AdminState has been set to Unlocked. Setting AdminState to
Unlocked may require a user action at the OAM workstation, or the
OAM system may be programmed to set it automatically. When
AdminState is Unlocked, the User indicator shows steady green.
LTE Indicator
When power is applied, the LTE indicator initially remains off. It starts
blinking slowly (green) when the E10xx is ready to bring the cell on air
(i.e. start transmitting and receiving) but cannot yet do so, either
because the E10xx is waiting for a signal from the OAM system to
allow it to do so, because it is waiting for a connection to the EPC to be
established or in the case of the E1012/CBRS waiting for an
authorised grant from the SAS. When the cell does come on air, the
LED shows steady green.