Install Drawing

ManualsBrandsGen-Tran ManualsGenerator AccessoryFlip Lid Accessory For Power Inlet Boxes

Optional FLIP LID For Power Inlet Boxes

For Models 53001/53002/53003, 14201/14202/14203, 14301/14302/14303, 63651/63652/63653

INSTALLATION INSTRUCTIONS

Warning: Installation of this Power Inlet Box and related wiring must be done by a qualified electrician in compliance with all applicable electrical codes. Power

Inlet Boxes provided with circuit breakers are designed for locations where the authority having jurisdiction has deemed that a “permanently installed generator

outdoors” is considered to be a separate structure, thus requiring a service entry disconnect.

This optional Flip Lid for Power Inlet Box models xxxx1, xxxx2 and xxxx3 is intended for applications when

covering the power inlet is desired, such as to keep out nesting insects, dirt, moisture, etc. Power Inlet Box

sold separately.

Installing the Flip Lid with Your Power Inlet Box:

Tools required:

1/4" nut driver

Flat Blade or Phillips Screwdriver

Included in This Kit:

Flip lid and rubber gasket

3 x 8-32 x .75 thread-cutting screws

ASSEMBLY INSTRUCTIONS:

NOTE: This Flip Lid MUST be installed PRIOR to wiring the Power Inlet Box.

1. Open the Power Inlet Box by removing the screw or hex nut on front of unit. Installation is simpler if there is enough space available to

remove the bottom plate (by removing the 4 screws).

2. Loosen “Green” screw on inlet and pull out green wire. If the Power Inlet Box is already installed/wired, remove the other screws

securing the other wires.

3. Remove flanged inlet from the bottom of the Power Inlet Box by removing (3) 8-32 screws on flange lip. Discard screws.

4. Line up flip lid with the three (3) holes on the bottom of the Power Inlet Box where the screws in Step 3 were removed.

5. Insert three 8-32 x .75 screws through the inlet flange and through the flip cover and into Power Inlet Box bottom holes, and tighten

evenly. Ensure gasket is wrapped around the inlet and not pinched. Note: if bottom plate was not able to be removed, pull all four

wires through the hole in the bottom plate and secure to inlet after it is slipped into the Flip Lid.

6. Wire the inlet per step (4) in POWER INLET BOX installation instructions.

7. Torque to 10 lb. inches.

Now, complete the installation of the Power Inlet Box following instructions on the other side.

Toll Free: 1-888-GEN-TRAN

Fax: 770-552-7756

www.gen-tran.com

PN 511751 Rev E