Install Drawing

PAGE 1
50A PLUGS AND CONNECTORS WIRING INSTRUCTIONS WARNING: To prevent electrocution make sure the cable is not connected to a power source before installing the pig or connector. Failure to comply with the following instructions could cause an electrical failure or fire. 1. Check to see that the rating on the plug or connector is correct for the installation 2. Select a cable of suitable capacity, service, and temperature rating.
PAGE 2
WIRING 125/250 VOLT DEVICES See reverse side for complete wiring instructions— 1. Strip the jacket from the proper end for the cable. Cable end for the PLUG: Cable end for the CONNECTOR: oh scm 2. Insert the black and green wires into the "Y" and "G" terminals, and tighten the two terminal screws. Note: The drawing shows the plug. The "Y" terminal is on the other side on the connector. 3. Twist the cable as shown and insert the red and white wires into the "X" and "W" terminals.