User's Guide

32
G. Settings Data Limit
To set a data limit when the device has used a certain amount of mobile data.
When the limit is reached, data automatically turns off and a notification appears.
(1) Path : Settings > Network & Internet > Data usage
(2) Touch Mobile data usage > > Set data limit.
(3) Touch Set data limit
(4) Enter a number. To switch between megabytes (MB) and gigabytes (GB), touch the down arrow.
(5) Touch SET.
2) Wireless Local Area Networks
Wireless local area networks (WLANs) allow the RP Series to communicate wirelessly inside a building.
Before using the RP Series on a WLAN, the facility must be set up with the required hardware to run
the WLAN (sometimes known as infrastructure). The infrastructure and the RP Series must both be
properly configured to enable this communication.
Refer to documentation provided with the infrastructure (access points, access ports, switches,
Radius servers, etc.) for instructions on how to set up the infrastructure.
Once the infrastructure is set up to enforce the chosen WLAN security scheme, use the Wireless &
networks settings configure the RP Series to match the security scheme.
The RP Series supports the following WLAN security options
- Open
- Wireless Equivalent Privacy (WEB)
- Wi-Fi Protected Access (WPA) / WPA2 Personal (PSK)
- Extensible Authentication Protocol (EAP)
The status bar displays icons that indicate Wi-Fi network availability and Wi-Fi status.
** Turn off Wi-Fi when not using it, to extend the life of the battery.
A. Scan and connect to a Wi-Fi network
(1) Path : Settings
(2) Slide the Wi-Fi switch to the ON position
(3) Touch Wi-Fi. The RP Series searches for WLANs in the area and lists them.