User's Manual

Ultra Thin Bicolor SMD LED USER MANUAL
12
INSTRUCTIONS
ADJUSTING
THE COLOR
TEMPERATURE
To change the color temperature,
follow these steps:
1. Press the mode button so the
color temperature indicator
appears on the screen.
2. Use the + or - buttons to adjust the
color temperature from 5600 K (daylight
balance) to 3200 K (tungsten balance).
Press the buttons to change the
temperature by 100 K increments. Press
and hold to change the value rapidly.
To adjust the color temperature with the
remote, and for more information about
using the remote with a multilight setup,
refer to the user manual included with
the Genaray MB-WRT wireless remote.
OPERATING
YOUR LIGHT
Open the barndoors, and press and hold the
power until the LED array turns on. The LED
display will show the last settings that were
used.
Modifying the Light Output
The brightness ranges from 10 to 99 (10% to
full brightness). To set the light’s brightness,
follow these steps:
1. Turn on the power.
2. Press the mode button so the brightness
indicator appears on the screen.
3. Press the + or - buttons to raise or lower
the value by one-unit increments. Press
and hold to change the value rapidly.