User Manual

SpectroLED Baton LED Stick Light - USER MANUAL
12
The Baton supports DMX-512, so
the light’s settings can be remotely
controlled from a DMX console.
To set up DMX operation on the
Baton, follow these steps:
1. Use the included 5-pin cable to attach
a DMX controller to either one of the
mini DMX ports. The other port will
automatically become the output port.
2. Use the other mini DMX port to connect
multiple lights.
Note: If the Baton is the only light
connected to the DMX controller, no
DMX termination is necessary.
3. Refer to the DMX controller’s user
manual to set its DMX address.
SETTING THE DMX ADDRESS
The DMX address is a 3-digit
number from 001 to 512.
1. Double-press the Mode button. The
three-digit DMX address will blink.
2. Press the Up/Down buttons to select
a DMX address in increments of 1.
3. Press the Mode button to set
the address and return to
brightness adjustment mode.
Important!
Make sure the DMX address on the Baton
matches the DMX console’s address.
USING DMX
instructions