User Manual

Contender LED Fresnel Spot Focusing Light - USER MANUAL
8
USING THE CONTENDER
WITH BATTERY POWER
Important!
The Contender will operate only
with both batteries installed.
To attach the battery module to the
Contender, follow these steps:
1. Unscrew the control module locking
ring, and remove the control module.
2. Align the power contacts of the battery
module with the contacts on the main
module, and connect the two modules.
3. Tighten the battery module
locking ring until secure.
4. Attach the control module to the
battery module by aligning the contacts
and tightening the locking wheel.
POWERING THE
CONTENDER
USING THE CONTENDER
WITH AC POWER
Important!
The Contender is a multivoltage fixture
capable of running on 100–240 V, 50/60 Hz.
The included cable has a 120 V, 50 Hz
(North American) plug. To use this fixture
with other voltages, you must use a
plug adapter (sold separately).
Make sure the unit is turned off. Connect
the AC power adapter to the Contender's
AC input, and insert it in until secure.
instructions