User Manual

SpectroLED STUDIO LIGHT - USER MANUAL
13
INSTRUCTIONS
REMOTE
CONTROL
GROUPING AND
SYNCHRONIZING LIGHTS
· A wireless remote control is included with each
Studio light. It can control both the Daylight
and Bi-Color light fixtures, as well as multiple
fixtures at once. You can use the remote to
increase or decrease light output, adjust color
temperature (Bi-Color version only), change
light output in increments of 25% (Daylight
versions only), and turn the power on or off.
will emit a long beep, indicating a
successful synchronization.
· You could also synchronize multiple
SpectroLED fixtures to a single remote,
allowing you to control all synced
lights in tandem. Syncing multiple
lights works the same as syncing a
single one – with the desired fixtures
powered on, press and hold the “A” and
“D” buttons on the remote.
· Note that while syncing, all fixtures
that are powered on and within range
will be synced. To sync some lights to
one remote and some to another, first
power on the first group, sync them,
then turn them off. Then, power the
second group on and sync those to
the other remote. When all lights are
turned on again, each will respond to
the correct remote.
· In order to use the remote, it first has to
be synchronized to the fixture. To sync,
make sure that the desired fixture is
powered on and within range of the remote
(approximately 65 feet, or 20 meters).
Press and hold the "A" and "D" buttons on
the remote at the same time. The fixture