User Manual

SpectroLED - USER MANUAL
9
OPERATING THE
SRL-10
INSTRUCTIONS
Power the SRL-10 on by turning the power
knob. The LCD screen will show the last
color temperature setting that was used.
After powering on the SRL-10, set the
brightness and color temperature using the
knobs on the back of the fixture.
· Color temperature can be adjusted
from 3200 to 5600 K in 100 K
increments.
· Brightness can be adjusted from
100% to 10% in 1% increments.
Turn the SRL-10 off by turning the
brightness knob all the way down until it
clicks off.
1. Make sure the power switch is in the Off
position, and the fixture is not plugged into
a wall outlet.
2. Place the battery down into the battery
compartment. Make sure the battery
contacts face the contacts in the battery
compartment.
3. Slide the battery toward the contacts until
it clicks into place.
To remove the battery, press the battery
release button.
The battery level indicator shows the
remaining charge in your batteries.
If the batteries are low, run the SRL-10
with one battery while the other charges.