User Manual

Square Sun Bi-Color Soft LED Flood - USER MANUAL
9
USING DMX
ADJUSTING BRIGHTNESS AND
COLOR TEMPERATURE
Open the barndoors, and power the
SS-12V2 on. The LCD screen will show
the last setting that was used.
After powering on the SS-12V2, set the
brightness and color temperature by
rotating the knobs on the back of the fixture.
· Color temperature can be adjusted from
3200 to 5600 K in 100 K increments.
· Brightness can be adjusted from
100% to 10% in 1% increments.
For quieter operation, turn the fan
off via the fan on/off switch.
Note
When the fan is turned off, the maximum
brightness will be capped at 80%.
The SS-12V2 supports DMX-512 so the
light’s settings can be remotely controlled
from a DMX lighting control console.
To setup DMX operation on the
SS-12V2, follow these steps:
1. Use a 3-pin XLR cable to connect a DMX
controller to the SS-12V2 DMX input jack.
2. Use the SS-12V2 DMX output jack
to connect multiple lights.
3. To set the DMX address on the
SS-12V2, press the dimmer
knob to activate DMX mode.
4. Turn the knob to select a DMX address.
Important
Make sure the DMX address on the
SS-12V2 matches the DMX console.
Press the dimmer knob again to
return to brightness control mode.
instructions