Manual

Figure 2. GLM Network cabling. Audio cabling not shown.
MICROPHONE
PLACED IN
THE LISTENING
POSITION
292-0063
GLM
TERMINATOR
COMPUTER
RUNNING
GLMSOFTWARE
USB CABLE
GLM ADAPTER
GLM NETWORK
CABLE
MONITORS
SUBWOOFER
AES/EBU Out
The AES/EBU Out is a bit-to-bit copy of
the digital audio signal on the AES/EBU IN.
This output can be used for digital sharing
of the audio between subwoofers in the
case where multiple subwoofers are used.
This output can also be used for distributing
a stereo digital audio signal to monitors.
This can create a 2.1 digital audio stereo
monitoring system.
Bypass
The Bypass input accepts a 6.3 mm tip-ring-
sleeve (TRS) or tip-sleeve (TS) plug. This
plug supports a contact open/close switch
device. Connecting the TIP to the SLEEVE
activates the bass management bypass.
When the bass management bypass is
active, the subwoofer only reproduces the
LFE signal and the outputs bypassed to the
monitors are exact copies of the inputs.
The Bypass switch is intended to be used
when the subwoofer is set up using the
controls built in the subwoofer.
The GLM software control enables also
bypassing the bass management and oers
a wider set of controls and adjustments.
When the GLM is used, the TRS bypass
control is not needed.
GLM Management Network
All controls and calibration features included
in the 7380A SAM subwoofer can be set using
the Genelec Loudspeaker Manager (GLM)
software. Two GLM Network connectors are
provided on the subwoofer for computer
control. These connectors accept CAT5 or
higher cable (RJ45 connector). Standard CAT
cables can be used.
The GLM management network runs a
proprietary protocol. This is not an Ethernet
connection, do not connect to an Ethernet
network.
Mains Power Input
The main power connection supports a
wide mains voltage range (100-240 VAC,
50-60 Hz). This enables the 7380A SAM
subwoofer to be plugged in anywhere
globally. When the mains power is provided
with a generator, inverter, or certain lower-
quality UPS devices, we recommend ltering
power to remove harmonics and ensuring
the voltage supply is stable.
Bass Management
Bass management divides the input audio
signal into low frequency and high frequency
content at the subwoofer crossover frequency.
The signal content below the crossover
frequency is reproduced by the subwoofer.
The signal content above the crossover
frequency is reproduced by the monitors.
The 7380A supports two bass
management methods: the centralized bass
management method and the distributed
bass management method.
Figure 1. Connector panel of the 7380A.
IN 3
IN 4
OUT 3OUT 4
IN 5
OUT 5
IN 6
IN 7
OUT 6OUT 7
LFEIN
LFE OUT
LINK OUT
LINKIN
OUT2
IN 1IN2
OUT1
TEST 1
TEST 2
GLM NETWORK
ANALOGANALOGANALOG
SERIAL
NUMBER
7380ASMART ACTIVE SUBWOOFER
RESET TO
FACTORY
SETTINGS:
PUSH BUTTON
FOR10 SEC
-4
0
+2
-2
-6
+4
+12
+8
PHASE
LFE +10 dB
STORED
ISS
TEST TONE
A/B
DIGITAL LFE
-20dB
-10dB
LEVEL
BASS ROLL-OFF
BYPASS
ON/OFF
LFE CHANNEL
ON OFF
-90°
-180°
-4 dB
-8 dB
INPUT dBu
100 dB SPL (1 m)
PRODUCING
MAINSINPUT
50 /60Hz 600 W
100 - 240 V~
MADE IN FINLANDwww.genelec.com
WARNING
ELECTRIC SHOCK HAZARD.DO NOT OPEN.DO NOT
SUBJECT TO WATER OR MOISTURE. NOUSER
SERVICEABLEPARTS INSIDE.REFER SERVICINGTO
QUALIFIED PERSONNEL.USE EARTHED MAINS
CONNECTION ONLY.
THIS DEVICE COMPLIES
WITH FCCPART15AND
CANADIANICES-003 RADIO
FREQUENCYCLASSBEMISSION
REQUIREMENTS. REFERTO
OPERATINGMANUALFOR FULL
INFORMATION.
LAITEONLIITETTÄVÄ SUOJAKOSKETTIMILLA
VARUSTETTUUN PISTORASIAAN.
APPARATETMÅ TILKOPLES JORDET STIKKONTAKT.
APPARATENSKALL ANSLUTASTILL JORDATUTTAG.
RISQUE DE CHOCÉLECTRIQUE.NEPAS OUVRIR. NEPA S
EXPOSERÀL'EAU OUL'HUMIDITÉ. AUCUN COMPOSANT À
L'INTÉRIEUR REMPLAÇABLEPAR L'UTILISATEUR.ADRESSER
TOUTE RÉPARATIONÀUN PERSONNELQUALIFIÉ.
CET APPAREILDOIT ÊTRERACCORDÉÀLATERRE.
AVERTISSEMENT
DIGITAL
OUT
IN
AES/EBU
IN/OUT
CONNECTORS
GLM NETWORK
CONNECTORS
ANALOG IN/OUT
CONNECTORS
POWER
SWITCH
MAINS
INPUT
ROTARY
LEVEL
ADJUSTMENT
CONTROL
SWITCHES
BYPASS
SWITCH
CONNECTOR