User Manual

English 3
8330A
RESET TO FACTORY
SETTINGS: PUSH
BUTTONFOR 10 SEC
COMPOSANTÀL'INTÉRIEURREMPLAÇABLEPAR
OUVRIR.NE PAS EXPOSERÀL'EAUOU L'HUMIDITÉ.AUCUN
L'UTILISATEUR.ADRESSER TOUTERÉPARATIONÀUN
PERSONNELQUALIFIÉ. CET APPAREILDOIT ÊTRE
RACCORDÉÀLATERRE.
NOTSUBJECTTOWATER ORMOISTURE. NO USER SERVICEABLE
PARTSINSIDE.REFER SERVICINGTOQUALIFIED PERSONNEL.
USEEARTHEDMAINSCONNECTION ONLY.
ELECTRICSHOCK HAZARD. DO NOTOPEN. DO
WARNING:
AVERTISSEMENT:
LAITEONLIITETTÄVÄ SUOJAMAADOITUSKOSKETTIMILLAVARUS-
TETTUUNPISTORASIAAN. APPARATETMÅTILKOPLES JORDET
STIKKONTAKT.APPARATENSKALL ANSLUTASTILL JORDATUTTAG.
MADE IN FINLAND
MAGNETICALLY SHIELDED
www.genelec.com
SERIALNUMBER
This devicecomplieswithFCC Part15and Canadian
ICES-003 radiofrequencyClassBemissionrequirements.
Refertooperatingmanualforfullinformation.
MAINSINPUT
50 /60Hz60W
100 - 240 V~
GLM NETWORK
SMARTACTIVE MONITOR
292-8030W
RISQUEDE CHOC ÉLECTRIQUE. NEPA S
DIGITAL
IN
292-8330T-6
ANALOG
IN
DIGITAL
OUT
+
- GND
2
3
112
3
GND
-
+
INOUT
GLM NETWORK
CONNECTORS
MAINS
INPUT
POWER
SWITCH
SIGNAL CONNECTORS
- DIGITAL IN
- DIGITAL OUT
- ANALOG IN
Figure 3: GLM Network Adapter
cabling. Audio cabling is not
shown.
LISTENING
POSITION
MICROPHONE
GLM
NETWORK
GLM
NETWORK
GLM
NETWORK
USB
Digital Audio Input
The 8330A digital audio input (DIGITAL IN) accepts
a male XLR connector carrying an AES/EBU format-
ted digital audio signal. The digital audio can be rout-
ed to the next monitor or subwoofer using an XLR
output (DIGITAL OUT). The AES/EBU digital audio
subframe A or B is selected using the GLM software.
Settings and Acoustic Calibration
The Smart Active Monitors are extremely flexible in
compensating the acoustic influences of the room
and support automated setup using the GLM User
Kit and software. The 8320A and 8330A are com-
patible with GLM 2.0 and later.
The GLM software can be downloaded from
Figure 2: Control and connec-
tor layout on the rear panel of
an 8330A. The 8320A has an
analog input only, and the GLM
network connectors point down-
wards and are located next to
the audio input.