8341A Smart Active Monitor Operating Manual
Introduction Acoustically Concealed Woofers (ACW™) Thank you for choosing a Genelec product! Fulfilling dreams by offering people the most truthful sound reproduction possible has been the source of our enthusiasm since 1978. There´s already over one million Genelec monitors around the world welcome to our story! All Genelec monitors are designed, hand assembled and tested at our factory in Iisalmi, Finland.
MICROPHONE PLACED IN THE LISTENING POSITION COMPUTER RUNNING GLM SOFTWARE 292-0063 GLM ADAPTER GLM TERMINATOR USB CABLE SUBWOOFER GLM NETWORK CABLE MONITORS Figure 1.
h2 h1 ACOUSTIC AXIS ACOUSTIC AXIS h1 = 195 mm (7 11/16 in) h2 = 138 mm (5 7/16 in) Figure 4. The location of the acoustic axis. User Kit. 4. Connect the microphone cable to the microphone input in the GLM Adapter device. 5. Download the GLM software at the Genelec web site (www. genelec.com). Install the GLM software and follow the instructions in the software to measure and set up your monitors. 6.
Colour Indication Solid greed Normal state, normal operation Blinking green GLM is adjusting the monitor Green blink every 10 sec. Monitor is in an ISS power saving sleep state Red blink Power amplifier overload protection is active (audio is modified because of protection) Solid red Monitor is muted Yellow Monitor is not in the active (playing) group Yellow blinking Overheat protection is active (audio is modified because of protection) Table 2.
service personnel. The monitor enclosure must not be opened. Opening the monitor may lead to loss of the individual monitor factory calibration and damage to components. necessary to maintain sufficient cooling. Do not obstruct airflow around the monitor. Safety Considerations The 8341A is capable of producing sound pressure levels in excess of 85 dB, which may cause hearing damage.
Genelec Oy 8341 16 May 2017 ms 40 35 30 25 used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
SIGNAL PROCESSING 8341A Analog signal input connector XLR female, balanced 10 kOhm pin 1 gnd pin 2 non-inverting pin 3 inverting Maximum analog input signal Analog input sensitivity (100 dB SPL at 1 m) Analog input sensitivity control +24.