User Manual

7
• Run AutoCal and review the results to check for large dips
at or above 85 Hz. Move the monitors and repeat AutoCal if
there is a problem.
• Press “Finish”, then in the Main Page select “Menu | Store
Acoustic Settings to All Online Monitors” and close GLM.
• For each SAM monitor, turn it off, select “Stored” on the
back of each monitor to activate the internal Acoustic
Settings, and then turn it on again.
• To set the phase control on the subwoofer, connect the
Center channel output of the subwoofer to the monitor to be
used to align phase.
• Follow the instructions in the subwoofer user manual for
setting phase and level.
Maintenance
No user serviceable parts are to be found within the monitor en-
closure. Any maintenance or repair of the monitor should only be
undertaken by a certified Genelec service.
Guarantee
Genelec 8240A, 8250A, 8351A and 8260A are supplied with a
two year guarantee against manufacturing faults or defects that
might alter the performance of the monitors. Refer to supplier for
full sales and guarantee terms.
Accessories
A wide selection of accessories is available for Genelec moni-
tors. Consult the Accessories Catalogue on www.genelec.com or
your local distributor/dealer for up-to-date information.
Compliance to FCC Rules
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable pro-
tection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the in-
structions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Modifications not expressly approved by the manufacturer could
void the user’s authority to operate the equipment under FCC
rules.
Safety Considerations
Although the 8240A, 8250A, 8351A and 8260A have been de-
signed in accordance with international safety standards, to en-
sure safe operation and to maintain the monitor under safe op-
erating conditions, the following warnings and precautions must
be observed:
• Servicing and adjustment must only be performed by a
certified Genelec service. The monitor enclosure must not
be opened.
• Do not use this product with an unearthed mains cable or
a mains connection without the protective earth contact as
this may lead to personal injury.
• To prevent fire or electric shock, do not expose the unit to
water or moisture.
• Do not place any objects filled with liquid, such as vases on
the monitor or near it.
• Note that the amplifier is not completely disconnected
from the AC mains service unless the mains power cord is
removed from the amplifier or the mains outlet.
• Free flow of air behind the monitor is necessary to maintain
sufficient cooling.
• Do not obstruct airflow around the monitors.
WARNING!
These monitors are capable of producing sound pressure levels
in excess of 85 dB, which may cause permanent hearing dam-
age.