8351B Smart Active Monitor Operating Manual
Introduction Smart Active Monitoring (SAM™) Thank you for choosing Genelec! Fulfilling your dreams by offering the most truthful sound reproduction has been the source of our enthusiasm since 1978. Already over one million Genelec monitors are in use around the world - welcome to our story! Genelec monitors are designed to last long our spare part support extends far into future. They are hand-built in Iisalmi, Finland, using certified sustainable methods.
MICROPHONE PLACED IN THE LISTENING POSITION COMPUTER RUNNING GLM SOFTWARE 292 0063 GLM ADAPTER GLM TERMINATOR USB CABLE SUBWOOFER GLM NETWORK CABLE MONITORS Figure 1.
h2 h1 ACOUSTIC AXIS ACOUSTIC AXIS h1 = 237 mm (9 5/16 in) h2 = 169 mm (6 10/16 in) Figure 4. The location of the acoustic axis. low cut-off. Attenuation can be selected by combining settings on one or more switches. Desktop reflection compensation The desktop control reduces frequencies near 160 Hz by 4 dB. This compensates the boost when the monitor is placed on a meter bridge or table. Bass Tilt Control The Bass Tilt control offers three attenuation levels for the response below 800 Hz.
Colour Indication Solid greed Normal state, normal operation Blinking green GLM is adjusting the monitor Green blink every 10 sec. Monitor is in an ISS power saving sleep state Red blink Power amplifier overload protection is active (audio is modified because of protection) Solid red Monitor is muted Yellow Monitor is not in the active (playing) group Yellow blinking Overheat protection is active (audio is modified because of protection) Table 2.
Genelec Oy 8351B dB SPL Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Modifications not expressly approved by the manufacturer can void the user’s authority to operate the equipment under FCC rules.
Figure 12. The signal path block diagram of the 8351B. SYSTEM SPECIFICATIONS Lower cut-off frequency, –6 dB < 32 Hz Upper cut-off frequency, –6 dB > 43 kHz Accuracy of frequency response, ± 1.
AMPLIFIER SECTION Bass amplifier short term output power Midrange amplifier short term output power Treble amplifier short term output power (Long term output power is limited by driver protection circuitry) 250 W 150 W 150 W Amplifier system THD at nominal output <0.