Manual
and compensate your monitors and
subwoofers.
If you want, you can save the acoustic
calibration settings into the monitors,
subwoofers, and 9301A units. This enables
the use of the calibration data with the
GLM network disconnected. Removing the
GLM network cable and powering down
and up the 9301A and other products on
the network enables the use of the stored
settings. The settings can be stored into
the 9301A using the Genelec Loudspeaker
Manager software menu item “Store | Store
the Current Group Settings…”.
To operate the system without having the
computer connected on the GLM network,
remove the USB cable connecting to the
GLM adapter, power down and then up the
9301A and other devices on your system.
This enables the stored settings. Please
note that the monitors and subwoofers have
a switch for selecting the use of the stored
settings, and this switch must be set ON.
Returning to factory settings
The room specic settings stored in a 9301A
can be erased by keeping the power switch
depressed for more than 10 seconds. This
returns the 9301A to the factory settings.
Operating Environment
The 9301A is designed for indoor
use only. The permissible ambient
temperature is 15-35 degrees Celsius
(50-95°F) and relative humidity 20% to
80% (noncondensing). When the product
has been stored or transported in cool
environment and is taken into a warm
room, wait 0.5-1 hours before opening
any packing to prevent condensation
of humidity before connecting to mains
power. Sucient cooling must be ensured.
No minimum clearance is needed.
Maintenance
There are no user serviceable parts inside
the 9301A. Maintenance or repair must
only be done by Genelec certied service
personnel.
Guarantee
Genelec guarantees the 9301A for two years
against manufacturing faults or defects
altering performance. Refer to the reseller
for full sales and guarantee terms.
Safety Considerations
The 9301A has been designed in accordance
with international safety standards. To ensure
safe operation, the following warnings and
precautions must be observed:
• Servicing and adjustment must only
be performed by Genelec certied service
personnel.
• The enclosure must not be opened.
• Do not use this product with a mains
cable or mains outlet having no protective
earth (potential equalizing) connection as
doing so may result in personal injury.
• To prevent re or electric shock, do not
expose the unit to water or moisture.
• Do not place objects filled with liquid,
such as vases, on the 9301A or near it.
• The 9301A is not completely
disconnected from the mains power unless
the mains cable is removed from the device
or the mains outlet.
Compliance to FCC Rules
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
• This device may not cause harmful
interference, and
• This device must accept any interference
received, including interference that may
cause undesired operation.
Note: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. There is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment o and on, the user is
encouraged to try and correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Modifications not expressly approved
by the manufacturer can void the user’s
authority to operate the equipment under
FCC rules.