User's Manual

Setting the tone controls
The frequency response of Genelec G Three,
G Four and G Five can be adjusted to match
the acoustic environment by setting the tone
control switches on the rear panel. The controls
are “Tabletop”, “Treble”, “Bass” and “Low
Bass”. Table 1 shows some typical settings
in various situations. Figures 3, 5 and 7 show
the effect of the controls on the frequency
response.
Tabletop
It is recommended to activate this switch to
‘ON’ when the loudspeakers are placed on a
table, desk or similar surface to minimise the
eect of such reective surfaces between the
loudspeakers and the listener.
Such a placement typically causes a
boost in one region of the bass spectrum.
The “Tabletop” control compensates for this
unwanted sound colouration.
Treble
The “Treble” adjustment allows modifying the
high frequency response of the loudspeaker.
The G Three has one setting, -2 dB for
smoothening down an excessively bright
sounding system, the G Four and G Five
provide two attenuation levels, -2 dB and -4
dB and one boost setting, +2 dB.
Bass
The “Bass” control offers three attenuation
levels for the bass response in frequencies
below 1 kHz, usually necessary when the
loudspeakers are placed near room boundaries
or other situations when the bass sounds too
dominant. The attenuation levels are -2 dB,
-4 dB and -6 dB. On the G Three, the -6 dB
attenuation is selected by setting both “Bass”
switches to “ON”.
Low Bass
The Low Bass control provides bass
attenuation at the lowest frequencies of the
loudspeaker’s bass reproduction. This may
be necessary if these deep bass frequencies
sound disproportionally strong. The G Three
has one setting, -4 dB and the G Four and G
Five provide three attenuation levels: -2 dB, -4
dB and -6 dB.
The factory setting for all tone controls
is “0” to give a flat anechoic frequency
response. Always start adjustment by setting
all switches to “OFF” position. Measure or
listen systematically through the different
combinations of settings to nd the best tonal
balance.
Mounting considerations
Align the loudspeakers correctly
Always place the loudspeakers so that they are
aimed towards the listening position. Vertical
placement is preferable, as it minimizes
acoustical cancellation problems around the
crossover frequency.
Maintain symmetry
Check that the loudspeakers are placed
symmetrically, and at an equal distance
from nearby walls. The distance between
the listening position and each loudspeaker
should also be identical. If possible, place the
system so that the listening position is on the
centerline of the room but not in the middle of
the front-back room dimension.
Minimize reflections
Acoustic reections from objects close to the
loudspeakers like desks, cabinets, shelves,
computer monitors etc. can cause unwanted
blurring of the sound image. These can be
Table 1. Suggested tone control settings in some typical situations
Loudspeaker Mounting Position Treble Bass Low Bass Tabletop
Flat anechoic response None None None None
Free standing in a damped room None -2 dB None None
Free standing in a reverberant room None -4 dB None None
Near the listener on a table or other
reective surface
None -2 dB None
ON (-4 dB @
160/200 Hz)
In a corner None -4 dB -4 dB None
Figure 1. The back panel layout of the G Three
MADE IN FINLAND
SERIAL NUMBER
This device complieswith FCC Part15and Canadian
ICES-003 radio frequencyClass Bemission requirements.
Refertooperatingmanual for full information.
292-G3BT
MAINS INPUT
50/60Hz60W
100-240 V~
www.genelec.com
RCA INPUT
XLR INPUT
ON
OFF
LOW BASS -4 dB
TABLETOP
TREBLE -2 dB
BASS
-4 dB
-2 dB
-6 dB
G Three
Active Loudspeaker
ISS
LED OFF
LEVEL -10dB
292-8030W
AVERTISSEMENT:RISQUEDECHOC ÉLECTRIQUE.NEPAS
OUVRIR. NE PAS EXPOSER ÀL'EAU OU L'HUMIDITÉ. AUCUN
COMPOSANT ÀL'INTÉRIEUR REMPLAÇABLE PARL'UTILISATEUR.
ADRESSER TOUTE RÉPARATIONÀUN PERSONNEL QUALIFIÉ.
CET APPAREILDOIT ÊTRE RACCORDÉ ÀLA TERRE.
LAITE ON LIITETTÄVÄ SUOJAKOSKETTIMILLA VARUSTETTUUN
PISTORASIAAN.
APPARATET MÅ TILKOPLES JORDET STIKKONTAKT.
APPARATEN SKALL ANSLUTAS TILL JORDAT UTTAG.
WARNING: ELECTRIC SHOCK HAZARD.DO NOT OPEN. DO NOT
SUBJECT TO WATER OR MOISTURE. NO USER SERVICEABLE
PARTSINSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
USE EARTHED MAINSCONNECTION ONLY.
REFLEX PORT
THREADS FOR
CEILING AND
WALL MOUNTS
TONE CONTROLS
CONNECTOR P
ANEL
(HORIZONTAL)
Iso-Pod™TABLE
STAND