Owner's Manual

Owner’s Manual for Power Zone Connectivity Server 9
Installation and Operation
Figure 3-3. Network Info and System Details
4. Select the SSID (Service Set Identifier) on the
mobile device or PC’s Wi-Fi list. Enter the network
password.
NOTE: The default Wi-Fi password (“generac123”) can
changed.
5. Once connected, open a web browser (Google
Chrome preferred) on the mobile device or PC and
enter the following Wi-Fi IP address in the top bar
of the browser:
– 192.168.25.1
Bluetooth Connection
1. Turn on Bluetooth on the mobile device or PC and
Select “Scan” or “Pair”.
2. Select the Power Zone BlueTooth device name on
the mobile device or PC’s Bluetooth list.
3. Once connected, open a browser (Google Chrome
preferred) on the mobile device or PC and enter
the following Wi-Fi IP address 192.168.25.1 in the
top bar of the browser.
Ethernet Connection
1. See Figure 3-3. To connect via Ethernet, the
Ethernet IP Address is required. This information
can be accessed via the Power Zone Pro Main
Controller “System Details” menu and by selecting
“Network Info” (C).
NOTE: The IP address and subnet mask on your PC's
Ethernet port must be set to a fixed IP address in the
same subnet range as the IP address of the connectivity
server.
2. Connect Ethernet cable from the Connectivity
Server to the PC.
3. Open a web browser (Google Chrome™ preferred)
and enter the Ethernet IP address in the top bar of
the browser. After a few minutes, the web browser
should display the Generac app.
Home Screen
See Figure 3-4. This screen displays bar graphs for the
most common measurements, and an overall health
check for the generator. The number of displayed
measurements will change depending on whether or not
the generator is running.
Figure 3-4. Home
/kWh
%
i
010067
007630