Owner's Manual

Owner’s Manual for Power Zone Connectivity Server 33

Installation and Operation

2. The connection can be initiated in two ways:

– Left mouse click on the menu item “Connect

using” ĺ “Access Point” (B).

– Right mouse click on the device that represents

the Connectivity Server (A) and select “Connect

using” ĺ “Access Point”.

Figure 3-72. Initiate Connection

3. A “Connection Successful” message will be

displayed.

4. See Figure 3-73. A network connection between

the devices has been established and the

Connectivity Server has assigned an IP Address

(A).

Figure 3-73. Assigned IP Address

5. Launch the web browser on the connected device

and go to http://192.168.25.1. Allow 20-30 seconds

for the Power Zone Application to load.

6. The Connectivity Server can now be accessed

using the web browser on the connected device.

Change Connectivity Server Bluetooth Name

1. See Figure 3-74. Select the text box field and

enter a new name (A).

2. Select “Apply Changes” (B).

Figure 3-74. Change Bluetooth Name

3. Confirmation of name change is displayed.

4. See Figure 3-75. New name is now displayed in

name text box (A).

Figure 3-75. Updated Bluetooth Name

Unpair Bluetooth Device

Unpairing from the Connectivity Server will break the

network connection between the two devices. After

unpairing, the procedure in Connect and View Power

Zone App on Web Browser of Connected Device must

be performed once again to establish a network

connection between the two devices.

1. See Figure 3-76. Select connected Bluetooth

device (A).

2. Select “Disconnect” (B).

009727

009728

009721