Use And Care Manual

ManualsBrandsGenerac PRO ManualsLog Splitters & ChippersGenerac® PRO 34-Ton Full Beam Gas Log Splitter

Owner’s Manual for 34 Ton Log Splitter 9

General Information and Setup

Know Your Log Splitter

See Figure 2-1. Be familiar with the controls and features

of the unit prior to operation. Read this manual thor-

oughly before assembling and operating this unit. Save

this manual for future and immediate reference.

Emissions

The United States Environmental Protection Agency (US

EPA) (and California Air Resources Board (CARB), for

engines/equipment certified to California standards)

requires that this engine/equipment complies with

exhaust and evaporative emissions standards. Locate

the emissions compliance decal on the engine to deter-

mine applicable standards. For emissions warranty infor-

mation, please reference the included emissions

warranty. It is important to follow the maintenance specifi-

cations in the manual to ensure that the engine complies

with the applicable emissions standards for the duration

of the product’s life.

Assembly

See charts below for list of included parts. Verify all parts

are included before assembling.

NOTE: Do not discard packaging materials until assem-

bly is complete and all parts accounted for.

Installing the Wheels

Figure 2-2. Parts Supplied in Hardware Kit #1

1. Remove plastic shipping caps from wheels. Verify

bearings remain seated when removing cap. Rein-

sert into the hub if bearing is dislodged.

2. See Figure 2-3. Block reservoir assembly up off

the ground and position wheel onto axle with valve

stem (A) facing out.

Figure 2-3. Wheel Assembly

3. Install castle nut (B) onto axle (C) and tighten

securely.

4. Loosen the castle nut and tighten it to the bearing.

Do not over tighten.

5. Insert cotter pin (D) through slots of castle nut and

into hole in axle.

6. Bend ends of cotter pin flush against castle nut.

7. See Figure 2-4. Install hub cap (E) onto wheel. Tap

gently with soft faced hammer to secure.

Figure 2-4. Hub Cap Installation

8. Repeat steps 1-7 for other wheel assembly.

Parts Supplied in Hardware Kit #1

Item # Description Qty

1 Hub cap 2

2 Nut, castle, 1-14 2

(000100a)

WARNING

Consult Manual. Read and understand manual

completely before using product. Failure to

completely understand manual and product

could result in death or serious injury.

006535

3 Pin, cotter 2

006536

006537