Use And Care Manual

Owner’s Manual for 34 Ton Log Splitter 11

General Information and Setup

4. See Figure 2-9. Coupling (B) may have separated

during shipping. Verify the two coupling halves are

together with the nylon insert (C) in the center.

Figure 2-9. Coupling Halves

5. See Figure 2-10. Install the pump assembly (D)

onto the engine shaft (E) with the opening facing

up, allowing the key to slide into the coupling. Push

the pump assembly onto the shaft until pump

mount (F) is flush with the engine. Temporarily

install a 5/16-24 bolt (G) to hold the pump against

the engine.

Figure 2-10. Engine Shaft Assembly

6. Remove one of the set screws (H) on the coupling

with a hex key. Apply thread lock to the set screw

and reinstall. Tighten the set screw to secure cou-

pling. Repeat for other set screw.

7. Remove temporary support bolt. Rotate pump

assembly so opening of pump mount is on bottom.

8. See Figure 2-11. Secure the pump assembly using

four 5/16-24 bolts, M8 lock washers, and M8 flat

washers (J). Tighten securely.

Figure 2-11. Pump Assembly

NOTE: The threaded fitting (K) must be on the top side

of the pump. If the threaded fitting is on top, continue to

step 10. If it is not, continue to step 9.

9. Remove four bolts and lock washers securing the

pump to the pump mount. Rotate the pump so the

threaded fitting is on top of the pump. Secure pump

to pump mount.

10. Remove plastic shipping cap (L) from bottom of

pump.

Installing the Engine

Figure 2-12. Parts Supplied in Hardware Kit #4

006542

006543

Parts Supplied in Hardware Kit #4

Item # Description Qty

1 Bolt, hex, M10 x 40 4

2 Washer, flat, M10 8

3 Nut, nylon lock, M10 4

4 Isolator, vibration 4

006544

006547