Use And Care Manual

ManualsBrandsGenerac PRO ManualsLog Splitters & ChippersGenerac® PRO 34-Ton Full Beam Gas Log Splitter

12 Owner’s Manual for 34 Ton Log Splitter

General Information and Setup

NOTE: Install washers so one washer is against head of

bolt, and other washer is against locknut.

1. Position engine with pump assembly onto engine

mount. Insert a vibration isolator between engine

and mount at four mounting hole locations.

2. Secure engine with four bolts, eight flat washers,

and four locknuts. Tighten hardware securely.

Installing the Beam Assembly

1. See Figure 2-13. Have an assistant help to stand

the beam upright on a flat level surface. Have the

assistant support the beam until beam is secured

to unit.

Figure 2-13. Beam Assembly

2. Remove pin and hitch clip (A) from beam support

bracket (B). Position reservoir assembly (C) with

beam support bracket in between the tabs (D) on

the beam assembly.

3. Slide pin through aligned tab holes and secure with

hitch clip. The tow bar may need to be lifted for the

holes to align. Use a team lift to accomplish this.

NOTE: Leave the beam assembly in the upright position

for the next procedures.

Installing the Hydraulic Hoses

NOTE: Each of the three hydraulic hoses is shipped with

one end fixed on the fitting. The hoses are labeled for

ease of installation.

1. See Figure 2-14. Oil suction hose (A), labeled 1,

comes from bottom of oil reservoir (C). Loosen

hose clamp (B) on open end of hose and connect

hose to fitting on bottom of pump. Tighten hose

clamp.

Figure 2-14. Oil Suction Hose Installation

2. See Figure 2-14 and Figure 2-15. Pump/valve

connecting hose (D), labeled as 2, comes from bot-

tom of valve on beam assembly. Apply a small

amount of hydraulic fluid to the o-ring (11 mm x 2

mm) (F) from hardware kit #3. Place o-ring into the

groove of the fitting on top of pump. Screw open

end of hose onto fitting on top of pump.

Figure 2-15. O-Ring Locations

3. See Figure 2-14 and Figure 2-15. Oil return hose

(E), labeled as 3, comes from front of the valve on

the beam assembly. Apply a small amount of

hydraulic fluid to the o-ring (G) (11 mm x 2 mm)

from hardware kit #3 and place o-ring into groove

at end of threaded fitting on oil reservoir. Screw

open end of hose onto oil reservoir.

NOTE: Verify hydraulic hoses are securely tightened at

both ends. Tighten as needed.

WARNING

Crush hazard. Use the help of another

individual to raise, lower, and install the beam.

Failure to do so could result in death, serious

injury, or equipment damage.

(000582)

CAUTION

(000429)

Pinch point. Use caution when handling

mechanisms on the unit, as they could be

pinch points. Failure to do so could result

in personal injury.

006548

006549

006550