Use And Care Manual

Owner’s Manual for 34 Ton Log Splitter 13

General Information and Setup

Installing the Control Handle

NOTE: Control handle is shipped hanging from valve on

handle link.

1. See Figure 2-16. Remove pin and hitch clip (A)

from control valve.

Figure 2-16. Control Handle Assembly

2. Rotate control handle (B) up into operating position

and secure with pin and hitch clip.

Installing the Log Trays

Figure 2-17. Parts Supplied in Hardware Kit #5

NOTE: Install washers so one washer is against head of

bolt, and other washer is against locknut.

1. Tighten hardware (A) on loosely assembled log

trays.

Figure 2-18. Log Tray Assembly

2. Lower the beam to the horizontal position with an

assistant. See Beam Operating Positions for

detailed information on raising and lowering beam.

3. See Figure 2-19. Position a log tray (B) onto beam

and loosely secure end plate with two M10 x 30

bolts (C), four M10 flat washers, and two M10 lock-

nuts. Repeat for the second log tray.

Figure 2-19. Attaching Log Tray

4. See Figure 2-20. Loosely secure bottom supports

(D) to beam with four M12 x 45 bolts (E), eight M12

flat washers, and four M12 locknuts.

Figure 2-20. Attaching Log Tray to Beam

5. Tighten the M12 hardware.

6. Tighten the M10 hardware installed in step 3.

Parts Supplied in Hardware Kit #5

Item # Description Qty

1 Bolt, hex, M12 x 45 4

2 Washer, flat, M12 8

3 Nut, nylon lock, M12 4

4 Bolt, hex, M10 x 30 4

5 Washer, flat, M10 8

6 Nut, nylon lock, M10 4

006551

006552

006553

006554

006555