Use And Care Manual

14 Owner’s Manual for 34 Ton Log Splitter

General Information and Setup

Installing Manual Holder

The manual holder is installed on the tow bar, near the

jack stand. All documentation should remain with the unit

at all times.

Figure 2-21. Parts Supplied for Manual Holder

1. See Figure 2-22. Position manual holder (A) over

pre-drilled mounting holes (B) on tow bar.

Figure 2-22. Manual Holder Mounting Position

2. Secure manual holder using hardware provided.

Installing Hour Meter

The hour meter is a reminder system that displays alerts

at regular intervals for oil changes, and displays accumu-

lated running times for long-term servicing needs.

Figure 2-23. Parts Supplied For Hour Meter

1. Position the mounting bracket over the pre-drilled

hole on the tow bar, located near the engine.

2. See Figure 2-24. Install the hour meter (A) into

mounting bracket (B) opening. Verify retaining clips

on hour meter snap into place.

Parts Supplied For Manual Holder

Item # Description Qty

1 Bolt, HCS, M8-1.25 x 80 2

2 Washer, flat, M8 4

3 Nut, nylon lock, ZP, M8-1.25 2

4 Manual caddy 1

008092

006969

Parts Supplied For Hour Meter

Item # Description Qty

1 Hour meter / 66 in (1.7 m) wire 1

2 Mounting bracket 1

3 Cable ties 3

4 Bolt, HCS, M8-1.25 x 80 1

5 Nut, nylon lock, ZP, M8-1.25 1

6 Washer, flat, M8 2

(000102)

WARNING

Accidental Start-up. Disconnect spark plug wire when

working on unit. Failure to do so could result in death

or serious injury.

008091