Manual

IMPORTANT:Sprayguntraps highwater pressure,evenwhen the
engineis stoppedandwater is disconnected.
:_ The highpressurestreamof waterthat this equipment
producescancutthroughskinand itsunderlying
tissues,leadingto seriousinjury,possibleamputation
or death.Spray guntrapshighwaterpressure,even
whenengineis stoppedand water is disconnected,
whichcancauseinjury.
• Keepthehighpressurehoseconnectedtothepumpandspraygun
whilethesystemis pressurized.
• ALWAYSpointthe spraygunin a safedirection,andsqueezethe
sprayguntriggerto releasehighpressureeverytimeyoustopthe
engine.Engagethetriggerlockwhennotin use.
OPERATION
If you haveany problemsoperatingyour power washer,pleasecall
Generaccustomer service at 1-888-436-3722.
POWERWASHERLOCATION
ClearancesandAir Movement
_ ANGER:Carbon monoxide producedduringuse CAN
KILL in minutes.NEVERuse indoorsor in other
shelteredareas, EVENIF doorsand windowsare open.
Onlyuse OUTSIDEand far awayfromwindows,doors
andvents.
NOTE:
For moreinformation,reference the Carbon Monoxide
warningsin theSafety Rules section.
Place the power washer outdoors, in an area that wilt not
accumulatedeadly exhaustgas. NEVERplace the power washer
where exhaust gas could accumulate and enter inside, or be
drawn into a potentially occupied building. Ensure the exhaust
gas is kept away from any windows, doors, ventilation intakes,
or other openings that can allow the exhaustgas to collect in a
confined area. Prevailingwinds and air currents should be taken
into considerationwhen positioningthe powerwasher (Figure19).
• OperatethepowerwasheroutdoorsONLY.
• Keepthe exhaustgas from enteringa confinedareathrough
windows,doors,ventilationintakes,or otheropenings.
• NEVERstart or run the engineindoors,or in an enclosedarea,
EVENIFwindowsanddoorsareopen.
_1_ Exhaustheat/gasescan ignitecombustibles,
structuresor damagethe fuel tank causinga
fire.
• Keep at least 5 ft. (152 cm) clearance on all sides of the power
washerincluding overhead.
Figure19 - Building Clearances
5 Foot Minimum
CHECKLISTBEFORESTARTINGENGINE
1. Be sure to read and understandthe OperatorSafety section
andthe Operationsection before using the power washer.
2. Check that oil is at the proper level in the enginecrankcase
andthat fuel has beenaddedto the fuel tank.
3. Reviewthe unit'sassemblyandensurethe fittings areproperly
secured.Also make surethere areno kinks, cuts, or damage
to high pressurehose.
4. Provide a proper water supply at an adequateflow, clear
screensof debris,andconfirm that the systemis purgedof air.
5. Confirm that the unit is on secure, level ground and the
surroundingwork areais clear.
HOW TOSTARTYOURPOWERWASHER
NOTE:
DO NOTrun the pumpwithoutthe water supplyconnectedand
turnedon. Damageto the equipment resultingfrom failure to
follow theseinstructionswill voidwarranty.
1. Movethe fuel valve leverto the ON position (Figure20).
Figure20- Fue/Va/ve
Off
11