Manual

9. After each starting attempt, where enginefails to run, always
point gun in safe direction, and squeezespray gun trigger to
releasehigh pressure.
10. If engine fails to start after six pulls, move choke lever to
"OPEN"position,and repeatsteps 6 through 10.
The highpressurestreamof waterthat this equipment
producescancutthroughskinand its underlying
tissues,leadingto seriousinjury andpossible
amputation.Spray guntrapshighwater pressure,even
whenengineisstoppedandwater is disconnected,
whichcancauseinjury.
, DONOTallowCHILDRENto operatepowerwasherorplaynearby.
* Keephighpressurehoseconnectedto pumpandspraygunwhile
systemis pressurized.
* NEVERaim spraygun at people,animalsor electricaldevices.
Seriousinjurywill result.
* DONOTsecurespraygunin openposition.
* DONOTleavespraygununattendedwhilemachineis running.
* NEVERuse a spraygunwhich doesnot havea triggerlockor
triggerguardinplaceandinworkingorder.
* Alwaysbecertainspraygun,nozzlesandaccessoriesarecorrectly
attached.
Contactwith mufflerarea canresultin seriousburns.Exhaustheat/gasescan ignite
combustibles,structuresor damage fuel tank
causinga fire.
* DONOTtouchhotpartsandAVOIDhotexhaustgases.
* Allowequipmentto coolbeforetouching.
* Keepat least5 feet (152cm)of clearanceon allsidesof power
washerincludingoverhead.
* It is a violationof CaliforniaPublicResourceCode,Section4442,
to useoroperatetheengineonanyforest-covered,brush-covered,
orgrass-coveredlandunlesstheexhaustsystemis equippedwith
asparkarrester,asdefinedinSection4442,maintainedineffective
workingorder.Otherstatesorfederaljurisdictionsmayhavesimilar
laws.
* Replacementpartsmust bethe sameand installedin the same
positionasthe originalparts.
AUTOMATICCOOLDOWNSYSTEM(THERMAL
RELIEF)
If you run the engine on your power washer for 3-5 minutes without
pressing the trigger on the spray gun, circulating water in the pump
can reach temperatures above 125°E The system engages to cool
the pump by discharging the warm water onto the ground.
HOWTOSTOPYOURPOWERWASHER
1. Release spray gun trigger.
2. Move throttle control lever on engine to "LOW" (turtle) position
(Figure 27).
Figure 27- ThmtUe Position
High Low
3. Turnthe engineON/OFFswitch to the "OFF"position.
4. ALWAYSpoint spray gun in a safe direction, and squeeze
spray gun trigger to release retained high water pressure.
Engagetrigger lock when not in use.
5. TurnOFFwater supply.
IMPORTANT:Spray gun traps high water pressure, even when
engineis stoppedandwater is disconnected.
The highpressurestreamof waterthat this equipment
producescancutthroughskinand its underlying
tissues,leadingto seriousinjury and possible
amputation. Spray guntrapshighwaterpressure,even
whenengineisstoppedand water is disconnected,
whichcancauseinjury.
* Keephigh pressurehose connectedto pump and spray gun while
system is pressurized.
* ALWAYSpoint spray gun in safe direction, squeeze spray gun
trigger to release high pressure, every time you stop engine.
Engagetrigger lock when not in use.
13