Manual

NOTE:
it may be necessaryto movethe handle supportsfrom sideto
side in order to align the handlesoit will slideover the handle
supports.
2. Installhose hook(Figure3).
Figure3 - InstallHoseHook
3. Insert color-colored nozzles in spaces provided in handle
(Figure4).
4. Placespraygunand nozzleextensioninto spray gunholderas
shown (Figure4).
Figure4 - InsertNozzles
5. Coil high pressurehose and hangon hook.
6. Attach siphon tube to locationA (Figure5).
Figure5 - SiphonTubeLocation
ADDENGINEOIL
1. Place powerwasher on a flat, level surface.
2. Clean area around oil fill and remove orange oil fill cap/
dipstick.
3. Usingoilfunnel (optional),slowly pour contentsof providedoil
bottle into oilfill opening.SeeMaintenancesectionfor oil type
recommendation.
NOTE:
Onsomeunits there is morethan one oil fill location.In these
instancesitis only necessaryto use one of the oil fill points.
4. Check periodicallyuntil the FULL mark is reached. DO NOT
OVERFILL.
NOTE:
Any attempttocrankor starttheengine before it hasbeen
properlyservicedwith the recommendoil may resultin engine
failure.
5. Replaceoil fill cap/dipstickand fully tighten.
ADDFUEL
Fuelmust meettheserequirements:
• Clean,fresh, unleadedgasoline.
• A minimum of 87 octane/87AKI (91 RON).
• Gasolinewith up to 10% ethanol (gasohol)is acceptable.
NOTE:
Avoid powerwasherdamage. Failure to follow Operator's
Manualfor fuel recommendationsvoidswarranty.
• DO NOTuse unapprovedgasolinesuch as E85.
• DO NOTmix oil in gasoline.
• DO NOTmodify engineto run on alternatefuels.
Toprotectthe fuel system from gelling,mix in afuel stabilizerwhen
addingfuel. SeeStorage.All fuel is notthe same. Ifyou experience
starting or performance problems after using fuel, switch to a
differentfuel provider or change brands.