Manual

Generac Portable Products 3500 PSIPressureWasher
5. Check to make sure there are no kinks, cuts, or
damageto high pressure hose.
6. Provide a proper water supply (not to exceed 100°F)
at an adequate flow.
7. Be sure to read "Safety Rules" and "How To Use Your
PressureWasher" before using the pressure washer.
HOW TO USE PRESSURE
WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at
1-800-270-1408.
How to Start Engine
The best way to start your pressure washer for the first
time is to follow these instructions step-by-step. This
starting information also applies if you have let the it sit idle
for at least a day.
I. Placepressure washer near an outside water source
capable of supplying water at a flow rate greater than
5.0 gallons per minute and no tessthan 20 PSIat
pressure washer end of garden hose.
2. Make sure unit is in a level position.
3. Check that high pressure hose is connected to spray
gun and pump. See"Preparing PressureWasher for
Use" for illustrations.
4.
5.
Connect garden hose to water inlet on pressure
washer pump. Turn ON the water.
Squeezetrigger on gun until you havea steady stream
of water. This purges pump of air and impurities.
CAUTION
6. Attach nozzle extension to spray gun. Tighten by hand
(Figure 4).
7. Apply safety latch to spray gun trigger (Figure 5).
SafetyLatch
8. Select desired quick connect spray tip and insert it into
end of nozzle extension (see "How To Use Spray
Tips").
9. Start engine according to instructions given in engine
owner's manual.
• Squeezetrigger on spray gun each time recoil starter is
pulled and engine fails to start.
NOTE: Always keep the Throttle Control leverin the
"Fast" position when operating the pressure w_sher.
How to Stop Pressure Washer
• Turn engine off according to instructionsgiven in engine
owner's manual.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water witt squirt out when you
release the pressure.
/
8