Manual

GeneracPortableProducts3500PSIPressureWasher
How to Use Spray Tips
The quick-connect on the nozzle extension allows you to
switch between several different spray tips. The spray tips
vary the spray pattern as shown below (Figure 6).
Follow these instructions to change spray tips:
I. Engagesafety latch on spray gun.
CAUTION
NEVERexchangespraytips without lockingthe safetylatch
on the trigger.
2. Pull back collar on quick-connect and pull current
spray tip off. Store spray tips in spaceprovided on
handles storage panel.
3. Select desired spray tip:
For gentle rinse, select white 40° or green 25°
spray tip.
To scour surface, select yellow 15° or red 0° spray
tip.
To apply chemical, select black spray tip.
4. Pullbackon collar, insert new spraytip and releasecollar.
Tug on spraytip to makesure it is securelyin place.
5. For most effective cleaning, keep spray tip from 8 to
24 inches awayfrom cleaning surface. If you get spray
tip too close, you may damage cleaning surface. DO
NOT get closer than 6 inches when cleaning tires.
Cleaning and Applying Chemical
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
CAUTION
Startingthe engine without all the hoses connectedand
without the water turned ON will damagethe pump.
Damage to equipment resulting from failure to follow this
instructionwill void warranty.
To apply detergent follow these steps:
I. Review spray tip use.
2. Prepare detergent solution as required by
manufacturer.
3.
Placesmall filter end of detergent siphoning tube into
detergent container.
CAUTION
• When insertingthe filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently contacting
the hot muffler.
4. Make sure black spray tip is installed.
NOTE: Detergent cannot be applied with the high
pressure spray tips (White, Green, Yellow, or Red).
Low Pressure \
Use to apply
chemical
Black White Green Yellow Red
40° 25° 15° 0°
High
Pressure
/
9