Owner's Manual

ASSEMBLY
[MPORTANT: Read entireowner'smanuai beforeyou
attempt to assembie or operate your new generator.
Carton Contents
Parts incmuded:
Generator
Wheei kit
Battery
Battery charge cabies
Battery float charger
Locking 20 Amp piug
Locking 30 Amp piug
Engine oii
Two packets of fuei stabilizer
Owner's manuaH
Engine manuaH
ff any of the above parts are missing or damaged_ cali the
generator heipiine at 1-800-270-m 408.
Attach Negative Battery Wire
The sealed battery on the generator is fuliy charged and
pre-installed except for the negative (biack) battery cabie.
To instamm:
I. Cut off tie wrap securing Hoose end of negative (bHack)
cable.
2. Connect negative (black) battery cable to negative (-)
terminal on battery (Figure I).
Negative
battery cable
Positive
battery cable
3. Verify that connections to battery and generator are
correct and secure.
Install Handle
To instali the handie you need the following tools:
o 2 o H3 mm (i/2") box, open end, or socket wrenches
Install handle as follows:
i. Remove hardware from bracket on handie.
2. Piace iifqng handie on aiternator end of cradie so that
handle fails between the two twistiock receptacles as
shown in Figure 2.Attach handle with provided cap
screws and hex nuts.Tighten with 13mm wrenches.
Capscrew
Hex
Nut
Handle