Hose Rework Drawing

HOSE REWORK - BLOCK HEATER KIT

G1.5L

Printed in U.S.A

Revision A (01/03/12)

GENERAC POWER SYSTEMS, INC. 757 N. NEWCOMB RD. WHITEWATER, WI 53190

TELEPHONE: (262) 473-5514 FAX: (262) 472-6515

Manual No. 0F4301AI

1. Measure and mark the “A” and “B” sections labeled in Figure 1.

2. Cut the hose to the lengths indicated by the marked cut lines.

3. Discard unused hose pieces.

4. Continue with the G1.5L Engine(G11) Block Heater Instructions on Drawing 0J6420.

SECTION “A”

SECTION “B”

CUT LINE

241

[9.5]

CUT LINE

CUT OFF THIS PORTION

AND DISCARD

MEASUREMENTS

LABELED

UTILIZE “SECTION A” FOR

BLOCK HEATER TO TEE

UTILIZE “SECTION B” FOR BLOCK HEATER

TO THERMOSTAT HOUSING NIPPLE

THIS HOSE PART NUMBER 0F4301A IS

MADE FROM PART NUMBER 0F4301

AND IS MODIFIED PER THIS PRINT.

FOR USE IN BLOCK HEATER KITS.

ISOMETRIC VIEW

NOT TO SCALE

CUT OFF THIS PORTION

AND DISCARD

[3.39]

279

[11.0]

[inches]

[1.5]

PAGE 1
Manual No. 0F4301AI H O S E R E W O R K - B L O C K H E AT E R K I T G1.5L GENERAC POWER SYSTEMS, INC. 757 N. NEWCOMB RD. TELEPHONE: (262) 473-5514 WHITEWATER, WI 53190 FAX: (262) 472-6515 1. Measure and mark the “A” and “B” sections labeled in Figure 1. 2. Cut the hose to the lengths indicated by the marked cut lines. 3. Discard unused hose pieces. 4. Continue with the G1.5L Engine(G11) Block Heater Instructions on Drawing 0J6420. UTILIZE “SECTION A” FOR BLOCK HEATER TO TEE SECTION “A” 241 [9.